Elastotec Crowned Diamond Ceramic lagging is designed to provide improved belt tracking in low to medium tension applications where existing rubber lagging is experiencing problems. Tapered end pieces (20mm12mm) with a 0.9 deg angle are vulcanised to a 20mm thick flat central section in a ration of approximately 1/3 – 1/3 – 1/3.


Improved belt tracking.
Suitable for low and medium belt tension applications.
Available in 250 mm wide strips that can be made to suit any pulley size and make it easy to install.
Available in highly abrasion resistant SBR for above ground applications and FRAS for underground and high risk applications.
Coloured wear indicator (Blue for SBR and Red for FRAS).
High quality rubber formulations designed for good bonding, resistance to degradation by out door exposure, and good abrasion resistance.
Buffed CN Bonding layer for increased adhesion for Cold Bonded application.
Available with uncured bonding layer for Hot Vulcanised application.
Tapered ends thickness from 20 mm to 12 mm. 0.9 degree angle.
Suitable for long term service at temperatures from -40C to +70C.


Crowned lagging strips typically 1/3rd flat center section, 1/3rd tapered end sections based on pulley face width.

 Save page as PDF